16
ADJUST THE RUNNING BELT
The running belt is well adjusted before being packed. After a period of use, the running belt may loosen or
deflect, which is normal. Then it is necessary to adjust the running belt, otherwise there will be friction damage
to the running belt.
Tension:
a)
Keep the machine at the speed of 3km/h.
b)
Put the multi-wrench into the left adjusting screw and turn clockwise by 1/4 circle.
c)
Put the multi-wrench into the right adjusting screw and turn clockwise by 1/4 circle.
d)
If necessary, repeat Step b and c as above until the running belt runs smoothly.
Note:
These four steps are available to tighten the running belt, if you need to loosen it, please turn anti-
clockwise.
Deflection:
a)
Keep the machine at the speed of 6km/h.
b)
If the running belt deflect to the left, put the multi-wrench into the left adjusting screw and turn
clockwise by 1/4 circle or put the multi-wrench into the right adjusting screw and turn anti-clockwise
by 1/4 circle. (Diagram 1)
c)
If the running belt deflect to the right, put the multi-wrench into the right adjusting screw and turn
clockwise by 1/4 circle or put the multi-wrench into the left adjusting screw and turn anti-clockwise by
1/4 circle. (Diagram 2)
d)
If necessary, repeat Step b and c as above until the running belt runs in the middle.
Deflect to the left (Diagram 1)
Deflect to the right (Diagram 2)
LUBRICANT (WHITE BOTTLE)
All treadmills were added lubricant before packed. However, it is still necessary to add lubricant after using the
machine for 30 hours or 30 days.
How to add lubricant:
a)
Cut a small hole at the head of the lubricant bottle. Make sure that the lubricant can be shot out from the
hole.
b)
Lift up the running belt and shoot the lubricant to the middle of the running board.
c)
Put down the running belt and put some pressure on the place where you add lubricant.
d)
Start the machine at the speed of 1 km/h for 1 minute.
