Inspiration S101 L, Owner'S Manual

Page: 84 / 96

84
DOC: OM-INSPIRATION-21G
Inspiration Spas 2021 Owner’s Manual
Probable cause #2: Circ pump is not running or pumping.
Action: Check if valves on circ pump/heater system are open (handle pulled up exposing valve
shaft, safety clips should be in place to prevent valve closure). Check if circ pump is
plugged in or if circ pump fuse in spa pack is burnt out.
Probable cause #3: Spa is not covered when not being used.
Action: Cover spa to retain heat.
Probable cause #4: Heater is not on due to error message showing on display.
Action:
Check for open gate valves on equipment, correct low water level in spa, and examine
condition of filter cartridge(s). Turn spa power off then back on. Monitor for reoccurring
error message on display. Contact dealer if problem persists.
Probable cause #5: System Input current setting is restricting heater operation.
Action: Consult dealer/electrician on system current setup and if a higher input current is
available from the supply. This may mean rewiring the spa with a larger gauge cable
and/or breaker.
Probable cause #6: Lack of insulation in a custom installation.
Action: Protect underside of spa from prevailing cold winds or snow. Enclose custom installations.
Jet(s) Do Not Come on When Pump Key is pressed
Probable cause #1: Jet pump is not plugged into spa pack.
Action: Plug pump in and test.
Probable cause #2: Jet pump fuse blown in spa pack.
Action: Locate & test/replace pump fuse in spa pack. Contact dealer if problem persists.
Probable cause #3: Jet pump is not primed.
Action: Shut off spa and allow trapped air to escape. Restart spa & check jet pump operation. If
problem persists bleed air at pump directly by opening union on pump until all
entrapped air is released. Retest.
Probable cause #4: Individually adjustable volume jets are adjusted to low volume.
Action: Turn face of specific jet to increase water volume.