Inspiration S101 L, Owner'S Manual

Page: 78 / 96

78
DOC: OM-INSPIRATION-21G
Inspiration Spas 2021 Owner’s Manual
If you look along the bottom section of the metal frame you should find two small pilot holes, each probably
about a third of the way in from each corner. If you place a screw in each hole (just a couple turns), you can
then rest the panel on top of these screws to balance it.
In an uncovered spa, over 90% of the heat loss is from the spa surface. The evaporation also affects the
chemical balance and could create humidity problems indoors.
Hard covers are engineered for maximum thermal efficiency and appearance. They are hinged in the middle
for easier handling, and the zippers allow the tapered Styrofoam inserts to be changed if damaged.
The skirt on the cover hugs the lip of the spa for a tight fit. The handles are placed so even a large cover can be
easily opened by 1 person.
The locks, with one part fastened to the deck or skirt, prevent small children or animals from entering the spa.
• Do not drag the cover across the spa or decking. Fold cover first, and then remove with assistance.
• Do not place the spa where snow loads are excessive on the cover. If snow accumulates on the cover,
carefully remove the snow.
• Do not shovel the snow as the cover will tear.
• Do not stand on the hard cover. The cover is not warranted against the foam breaking or the vinyl
cover tearing.
• Do not use abrasive cleaners or leather restoration-type cleaners. Use only water and a mild detergent.
Several of the jets in your spa are volume adjustable. The volume adjustment of the jet internals in these jets can
be effected by debris in the spa water. If you feel the volume adjustment getting stiff, you should consider
removing and washing the internal at the next scheduled fill and drain of the spa.
To Remove an Adjustable Jet Internal
1) Turn the jet face to the maximum volume position (fully counter clockwise).
2) The jet face will feel as if it has stopped but if you continue to turn the face, the jet internal will thread
out of the body.
3) Check the inside of the jet body and the internal for any debris and calcium build up.
4) Wipe out the inside of the jet body, if necessary.
5) Wash the internal in your service sink. Scrub, gently, if necessary.
6) To re-install a jet internal simply thread the internal in until it stops. Now continue turning until the internal
locks into its volume adjustment range.
If you find high levels of calcium build up or any discolouration of the jet internal when removed, you should
take a spa water sample to your dealer for testing.