Inspiration S101 L, Owner'S Manual

Page: 12 / 96

12
DOC: OM-INSPIRATION-21G
Inspiration Spas 2021 Owner’s Manual
Please note the following important information:
When using this electrical equipment, basic safety instructions should be followed, including the following:
Read and Follow ALL Directions
1) Electrical installation must be carried out by a qualified electrician strictly in accordance with
local governing codes.
2) A terminal marked "ground" is located within the control box. To reduce the risk of electric
shock this terminal must be connected to the grounding means provided in the electric supply
service panel with a continuous copper wire equivalent in size to the circuit conductors
supplying the equipment.
3) At least two lugs marked "bonding lugs" are provided on the external surface of the control
box. To reduce the risk of electric shock connect the local common bonding grid in the area
of the hot tub or spa to these terminals with an insulated or bare copper conductor not smaller
than No. 6 AWG.
4) All field installed metal components such as rails, ladders, drains or other similar hardware
within 3m (10 ft.) of the spa or hot tub shall be bonded to the equipment grounding bus with
copper conductors not smaller than No. 6 AWG.
5) Test the ground fault circuit interrupter before each use of the spa.
6) Before servicing any electrical components of the system make sure that the power supply is
switched off.
ATTENTION: ELECTRICIAN & SPA OWNER
PICO FUSE
Balboa Spa packs contain a special fuse, referred to a “Pico fuse”.
This special fuse is designed to open (burn out) if:
a) There is any problem with how the electrical supply is connected
b) There is a power surge to the spa pack
This fuse is not replaceable and the entire spa pack is considered destroyed.
WARNING!
THIS IS NOT A CONDITION THAT IS COVERED UNDER THE
SPA PACK MANUFACTURER’S WARRANTY OR
LEIS URE MANUFACTURING’S COMPREH ENSIVE SPA WARRANTY.