Inspiration S101 L, Owner'S Manual

Page: 13 / 96

Inspiration Spas 2021 Owner’s Manual
DOC: OM-INSPIRATION-21G
13
This unit has been built, tested and approved with a cord connected 115VAC built in Ground Fault Circuit
Interrupter (GFCI).
The cord must only be plugged into a receptacle that is connected to a
dedicated 15A breaker or fuse.
DO NOT extend the connection by the use of an extension cord. This will
void the warranty and could cause damage to the spa and its’ users.
GFCI Test Procedure:
1. With the GFCI plugged into a grounded 115VAC, 15A outlet
press the yellow TEST button.
2. The spa should shut off and a small light between the TEST and
RESET buttons should be lighted.
3. Press the red RESET button to reset the GFCI and start the spa.
FAMILIARIZE yourself with the test procedure for the GF CI. TEST the GFCI upon every use of the spa.
If the GFCI does not shut the spa off when the TEST button is pressed or does not start up when the RESET button
is pressed DO NOT USE THE SPA. Contact your dealer and/or a qualified electrician immediately. Take steps to
ensure that no person(s) can use the spa while the problem is being reviewed and corrected.
Note: In new installations, GFCI trippings due to mis-wiring are very common.
If the breaker is properly wired, GFCI trippings can occur when the total amount of current drawn by the spa
exceeds the rating of the breaker. Such an occurrence, however, is very unlikely, since each output of the spa
pack is individually fused and fuses will blow before the GFCI trips. A current leak to the ground will also make
the GFCI trip. If one or more of the components is faulty and there is a leak of more than 5 mA, the GFCI will trip
to prevent electrocution.
CAUTION:
Electrical installation must be carried out by a qualified electrician
strictly in accordance with local governing codes.
Use only Class A Ground Fault Circuit Interrupter.
BP SERIES SPA PACK
Power Requirements
240VAC, 60Hz, Class A GFCI-protected service
4 wires (Hot-Line 1, Hot-Line 2, Neutral, Ground)
For current requirements & breaker rating see nameplate on spa.
Power Up Screen
Each time the system powers up, a series of numbers is displayed. After the start-up
sequence of numbers, the system will enter Priming Mode. Next, refer to the User
Guide for your keypad at the back of
this manual.