7
8
Remove method
ａ
2
3
1 Press the driver unit toward arrow 1 and lift it toward arrow 2.
Remove the driver unit from the fixed plate.
2 Pull the driver unit in the direction of arrow 3 and take out the drive
unit.
9
Extension cable usage
If the drive unit is not installed on the main display unit, please connect
the main display unit and the drive unit with the extension cable as
shown in the following figure before using it.
1
Preparation for Measurement
Switch-on to check if battery voltage is normal;
Clear the surface of part to be measured;
Place the instrument correctly, stably and reliably on the surface to be
measured;
Trace of the pickup must be vertical to the direction of process line of
the measured surface.
Measuring Operation
2
Turning On/Off
Press the POWER key to hold 2 seconds after the instrument will
automatically boot, boot will display type, name and manufacturer
information, and then enter the basic measurement status main display
interface.
In any state, press the POWER key to hold 2 seconds after the
instrument will be turned off.
Introductions
：
1. The next boot will be displayed when the last shutdown set content.
2. Startup and shutdown, press and hold the key for about 2 seconds to
open the instrument will perform the appropriate action.
3. Long time not to use, the instrument should be on the side of the
power switch turned off.
3
Pickup Position
First, view pickup position to determine the location of the sensor. The
best location is in the middle position of the range.
Arrow indicates if it is not at zero point. The instrument can also be
measured normally.
As long as the entire measurement process does not exceed the set
range, it will not affect the measurement results.
