5
6
When battery voltage is too low (that is, battery voltage symbol display
on screen to prompt low voltage), the instrument should be
charged as soon as possible. USB port of the instrument for charging.
You can use the built-in power adapter for charging, you can also use
computer's USB port for charging. If use the other power adapter for
charging, the output voltage should be 5V DC , the current should be
greater than 1000mA.
Instrument displays charging animation when charging after full
animation ends, the display is full of symbols. Charging time of 5
hours.
This instrument adopts lithium ion chargeable battery without memory
effect and charging can be fulfilled at any time without affecting normal
operation of the instrument.
6
Battery Charging
6
6
6
6
6
6
6
7
Connection method of sensor and drive unit
When installing and remove sensors, turn off the power first.
ａ
2
2
3
1 sensor 2 Socket of drive unit 3 Drive unit
For installation, hold the main body of sensor with hand, push it into
socket at the the drive unit as shown in Figure and then slightly pushed
it to the end of the sheath. To remove, hold the main body of sensor or
the root of protective sheath with hand and slowly pull it out.
1. Sensor is key part of this tester and great attention.should be paid to
it.
2. During installation and remove, the stylus of sensor should not be
touched in order to avoid damage and affecting measurement.
3. Connection of sensor should be reliable during installation.
4. The sensor doesn't need to be removed when not in use.
5. Calibration is recommended after each new sensor is installed.
8
Connection method of Drive unit and Main Display unit
ａ
2
Installation method
1 The driver unit is embedded into the main display unit according to
the direction of arrow 1, so that it is installed on the fixed pin shaft.
2 Press the drive unit in the direction of arrow 1 and down the direction
of arrow 2 to install the driver unit on the fixed plate.
