3
Specifications
Measure Range: 0 100HD
~
Measure accuracy:
≤
1HD
±
Data capacity: 500
Voltage: 3.6V (rechargeable Ni-MH battery)
Continuous working time by one time charge: about 20 hours
Battery charge time: about 3 hours
Work temperature: 0°C~+50°C
Work humidity: 20%~85%
Storage temperature: -30°C~+80°C
Storage humidity: 5%~95%
Outline size: 153mm×50mm×29mm (main body)
Weight: about 171g
Strut diameter of the needle: (1.25±0.10) mm
The top plane diameter of the needle: (0.10±0.01) mm
The top cone angle of the needle: Initial verification: (30±0.5)°
Operation Instructions
1. Button and measure interface
1) Button
Power/Return: By pressing this button, the durometer will be power
on. By long time pressing this button, the durometer will be power
off. By pressing this button, the screen will return to the upper level
menu.
pressing this button. Under the menu interface, it will enter the next
menu interface. In addition, it is the confirmation button under function
selection or parameters setting interface.
OK: Under the measure interface, it will enter the menu interface by
Fig 3-1
14
Low-voltage alarming and recharge
The durometer will be recharged by the packaged charger. The
durometer will not be auto power on during recharging. The charging
status will show on the measuring interface by hand power on. The
moving of the battery level icon line indicate it is charging now. If the
icon fill by all line, it means the charging process is finished. If the power
is low, the battery level icon will flash to prompt to be recharged in time.
Reset
Software reset: if the software abnormal is happened, the durometer
will reset automatically.
Hardware reset: the durometer can be reset by the hardware reset
under the crash. The reset button is local in the hole of the back shell.
Data printing
Digital durometer can connected to the special mini-thermal printer to
print the hardness result report. The mini-thermal printer is optional part.
If it is needed, please contact the distributor.
The printer should be put near to the durometer and the distance
shouldn't be over 3m.
1. Format of the report
A full report is as the figure 7-1. Ps:1.the print content can be
customized by the relative menu explain on above.
The date/time in the report content is the measuring date/time. The
date/time at the end of the report is the print date/time.
Fig 7-1
