10
DOC
SW
‐
25
‐
F
2.2010
www.insingermachine.com
Installation Instructions
Step 1 READ
: Read and understand these instructions thoroughly before attempting any part of the
installation procedure.
WARNING:
Not
following
these
instructions
may
void
warranty,
cause
damage
to
the
equipment
and/or
cause
injury
to
anyone
involved
in
the
installation
or
operation
of
this
machine.
A copy of the installation instructions and startup procedure is printed on the yellow sheet attached to
the side of the machine. EVERYONE involved with the installation must be familiar with all aspects of
the installation procedure.
Step 2 POSITIONING
: The factory recommends leaving as much room as possible around the machine
for future service work. No less than 16" should be allowed along the sides of the machine (36" for
side with control box) and no less than 12" between the rear of the machine and the wall. Extra room
around the machine will facilitate cleaning the washer area.
Note: Gas models should be installed in a location free of drafts.
Step 3 UNCRATING
: Leave the machine fully crated until the washer is placed in the location where it is
to be installed. After the washer is uncrated, remove the tape that holds the door weight stationary on
the back of the machine. This will allow the door to open. Inside you will find the accessories for the
machine. Among these will be the fan (if ordered) and the legs. Remove the machine from the pallet,
install the legs, and level the machine. The legs are adjustable by turning the small end one way or the
other.
Step 4 DRAIN
: Provisions for the drain should be made next. The pan washer has a copper drain located as
shown on pages 26 and 27 of this manual (see page 6 for drain size). The drain should be plumbed
according to local code. Local ordinance may require a grease trap, vent, and/or a floor sink. If
required, these should be installed before the machine is installed. It is strongly recommended that
unions be used to allow the machine to be easily moved. Failure to do so may void the warranty.
Step 5 WATER SUPPLY HOOKUP
: The factory recommends 140° F (120° F minimum) hot water at
the machine (see page 6 for water line size). This may require a dedicated water heater for the pan
washer. If hard water is present, the manufacturer recommends installing a water softener or calcium
filter. Hard water deposits will shorten the life of many of the components on the pan washer, resulting
in higher maintenance costs. Please note that a union is installed at the point of hookup (see pages 26
and 27). This will allow the machine to be moved for service and cleaning. The customer must furnish
a shutoff valve on the supply side of the union. This shutoff should be easily accessible to the operator
of the machine.
