NVC 360 User’s Guide
Rev.0.1 (Dec.2007)
15
2.6. Quick Installation Guide
Brief information for rapid installation is provided in this section. For more detailed information you are
recommended to refer to pertinent documentations provided with the product or refer to Inscape Data’s home
page
(http://www.Inscape Data.com)
1. Apply power to NVC 360 and Connect NVC 360 to LAN like the following picture.
Fig. 2-5 Connecting Network camera and PC
2. Install “IP installer” and “NVR100” on your PC.
Detailed information for installing these programs can be found in
[IP-Installer User’s Guide]
and
[NVR100 User’s Guide]
,
respectively.
3. Assign IP address to NVC 360 using IP installer.
Identify the type of the network environment and set up IP address. Detailed process of setting up IP
address can be found in
[IP-Installer User’s Guide]
.
If network type is xDSL or Cable modem you need
supplementary information provided by your ISP.
4. Connect to NVC 360 in Administrator Mode for initial parameter set-up.
All parameters are set to factory default state when NVC 360 is delivered. You are asked to configure
the system for your environment in administration mode. Detailed information of using administration
mode can be found in
[
5.
Configuring NVC 360 in Administrative Mode]
. Among the parameters, the
HUB
DC 12V Adapter
