Inovance MD320 Series, User Manual

Page: 135 / 202

MD320/MD320N User Manual Parameter Description
:KHQ PXOWLSOH LQYHUWHUV GULYH WKH VDPH ORDG WKH XQEDODQFHG ORDG GLVWULEXWLRQ GXH WR
difference speed causes the inverter with faster speed to carry heavier load. The droop control
FKDUDFWHULVWLFVFDXVHWKHVSHHGGURRSFKDQJHDORQJZLWKWKHDGGLWLRQRIORDGZKLFKFDQOHDGWR
balanced load distribution.
This parameter is used to adjust the frequency change value of the inverter with droop speed.
F8-16
Over modulation active
Factory default
value
1
Setup range 0 Over modulation inactive
1 Over modulation enabled
Over modulation function means that the inverter can improve the output voltage by adjusting
the use ratio of the bus voltage when the input voltage is relatively low or the inverter always
ZRUNVXQGHUKHDY\ORDG:KHQWKHRYHUPRGXODWLRQLVHQDEOHGWKHRXWSXWFXUUHQWKDUPRQLFV
will slightly increase.
This function can select whether the over modulation function is enabled.
F8-17
Setup running time
Factory default value 0h
Setup range
KWRK
It is sued to preset the running time of the inverter.
:KHQWKHDFFXPXODWHGUXQQLQJWLPH)UHDFKHVWKLVVHWXSUXQQLQJWLPHWKHPXOWLIXQFWLRQDO
digital DO of the inverter outputs the signal of running time arrival.
F8-18
Start protection selection
Factory default value 0
Setup range 0 No protection
1 Protection
7KLVIXQFWLRQFRGHLVXVHGWRLPSURYHWKHVDIHW\SURWHFWLRQFRHI¿FLHQW,ILWLVVHWWRLWKDVWZR
UROHV¿UVWLIWKHUXQQLQJFRPPDQGH[LVWVXSRQLQYHUWHUSRZHURQLWPXVWFDQFHOWKHUXQQLQJ
command to remove the running protection status.
6HFRQGLIWKHUXQQLQJFRPPDQGH[LVWVXSRQLQYHUWHUIDXOWUHVHWLWPXVWFDQFHOWKHUXQQLQJ
command to remove the running protection status.
,QWKLVZD\LWFDQSUHYHQWWKHDXWRPDWLFUXQQLQJRIWKHPRWRUXQGHUXQH[SHFWHGFRQGLWLRQV
F8-19
Frequency detection
value
(FDT level)
Factory default
value
+]
Setup range
+]aPD[LPXPIUHTXHQF\
efesotomasyon.com