Inovance MD320 Series, User Manual

Page: 107 / 202

MD320/MD320N User Manual Parameter Description
F2-09
Torque upper limit source
Factory default value 0
Setup range
0 F2-10
1 AI1
2 AI2
3 AI3
4
38/6(VHWXS
Communication setup
F2-10
Torque upper limit
Factory default value
Setup range
a
,QWKHVSHHGFRQWUROPRGH)LVXVHGWRVHOHFWWKHVHWXSVRXUFHRIWRUTXHXSSHUOLPLW:KHQ
VHWWLQJYLDWKHDQDORJYDOXHRIWKHDQDORJLQSXWVHWXSFRUUHVSRQGVWR)DQGWKH
setup 100% corresponds to the rated torque of the motor matching the inverter.
,QWKHWRUTXHFRQWUROPRGHWRUTXHXSSHUOLPLWVRXUFHLVWKHWRUTXHVHWXSVRXUFH7RUTXHXSSHU
limit is the torque setup command.
F2-11
Encoder pulse number
Factory default value 1024
Setup range
a
It is used to set the number of pulses of each turn of encoder.
&DXWLRQ:KHQWKHLQYHUWHUFRQWUROVWKHVSHHGVHQVRUYHFWRUFRQWUROLWPXVWVHWWKHSXOVH
QXPEHURIWKHHQFRGHUFRUUHFWO\RUWKHPRWRUZLOOUXQDEQRUPDOO\,IQRUPDORSHUDWLRQFDQQRW
EHUHDOL]HGDIWHUFRUUHFWSXOVHQXPEHURIWKHHQFRGHULVVHWH[FKDQJHWKHFRQQHFWLQJSRVLWLRQV
of Phase A and Phase B of the encoder.
7KLVJURXSRIIXQFWLRQFRGHLVHQDEOHGRQO\IRUWKH9)FRQWURO) DQGLVLQDFWLYHIRUWKH
vector control.
V/F control is applicable to the general loads such as fan and pump or the applications where
one inverter drives multiple motors or the inverter power is one level lower or higher than the
motor power.
Group F3 V/F Control Parameters
F3-00
V/F curve setup
Factory default value 0
Setup range
0 Straight V/F curve
1 Multiple-point V/F curve
2 Square V/F curve
The fan and pump loads may select square V/F control.
0: Straight V/F curve. It is suitable for common constant torque load.
1: Multiple-point V/F curve. It is suitable for the special loads such as dehydrator and centrifugal
efesotomasyon.com