Inoksan BYM052, User Manual

Page: 14 / 49

14
-Machine may have been
overloaded.
3 -The device does not take
water.
-Water inlet valve may be closed.
-Cover
may not be closed
completely.
-Solenoid valve may be broken.
-Check/Open
-Check/Close
-Notify the authorized service.
4 -The device continuously
takes water.
-Pressure stat may be defective.
-Pressure stat hose may have taken
in air. -Notify the authorized service.
-Empty the water inside the tank and restart the
device.
5 -There is rusting on the
device surface
-Improper chemical materials
may have been used. -Clean the device according to the instructions for use
BYM052 Malfunction Codes:
In case of malfunction, your device turns itself OFF and the related malfunction codes are displayed on the
screen
(as can be seen above) .

Malfunction codes are removed by themselves when the Sensor and Thermal malfunctions are solved.

To remove other codes, push the ON/OFF button.
DE
1. ERKLÄRUNG
1.
Die Anweisungen dieser Anleitung beinhalten
wichtige İnformationen über die zuverlässige
Montage, Gebrauch, Reinigung und Pflege
des Gerätes. Bewahren sie deshalb diese
Gebrauchsanweisung an einem durch den
Verbraucher
und Techniker leicht
erreichbaren Ort auf.
2. Die Montage des Gerätes sollte durch einen,
vom Hersteller der Maschiene beauftragten
und erfahrenen Fachexperten, den
Anweisungen der Firma anpassend
durchgeführt werden.
3. Die Wasser und Strom Verbindungen des
Gerätes sollten den Werten der Tabelle der
“Technischen
Eigenschaften” anpassend
gemacht werden.
4. Das regelrechte Funktionieren und
Langlebigkeit ihrer Spülmaschiene
hängt zweifellos vom richtigen
DESCRIPTION DETECTION
ER 01
NO WATER
Malfunction
Tank pressurestat does not detect the water level for 10 min. if its
position is not changed.
(if no signal is received for 10 min. at input no.9 during machine
water intake)
ER 02
Boiler NTC Malfunction Sensor short or open circuited
ER 03
Tank NTC Malfunction Sensor short or open circuited
ER 04
Boiler HEATER
Malfunction
When temperature increase of at least 5 ºC(41°F) is not ensured for
10 min. in the boiler.
(To be controlled when the boiler output no.11, i.e. the K2
contactor, has been working for at least 10 min. continuously.)
ER 05
Tank HEATER
Malfunction
When temperature increase of at least 5 ºC(41°F) is not ensured for
15 min. in the tank.
(To be controlled when the boiler output no.10, i.e. the K3
contactor, has been working for at least 15 min. continuously.)
ER 06
Thermal Relay or
Power-box Malfunction
When there is no energy at washer pump thermal relay output
(When there is no energy at input no.16 of the electronic card)