Heating on value
Cooling on value
12.0
℃/
53.6°F
30.0
℃
/ 86
°F
Day Mode
Low humidity
protection value
10.0
℃
/ 50
°F
Heating on value
12.0
℃
/ 53.6
°F
Deadband
2.0
℃
/ 35.6
°F
High humidity
protection value
35.0
℃
/ 95
°F
OFF state
Heat & cool mode
OFF state
Cool mode
OFF state
Heat mode
Default working
Mode
10.0
℃
/ 50
°F
Low humidity
protection value
Night Mode
30.0
℃
/ 86
°F
Cooling on value
35.0
℃
/ 95
°F
High humidity
protection value
2.0
℃
/ 35.6
°F
Deadband
Default Parameter
Parameter Type
Working M ode
[Heat] target value: When the current temperature of the device is lower than this value, then the
heating is started. The target value set needs to be lower than the high temperature protection value
minus the deadband value, and needs to be higher than the low temperature protection value.
[Cool] target value: When the current temperature of the device is higher than this value, and the
cooling is started. The target value set needs to be higher than the low temperature protection value
plus the deadband value, and needs to be lower than the high temperature protection value.
[Deadband]
value: The value set needs to be lower than (Cool target value minus heat target
value)/2 and the value needs to be greater than 0.
[Low Temp Protection] value: The value set needs to be lower than the [Heat] target value of
cooling & humidification.
[High Temp Protection] value : The value set needs to be higher than the [Cool] target value of
heating.
After the data are set, the Save button will light up. At this time, press the Save button to save the data,
after which a dialogue box will pop up prompting you to save the data; the data modified will not take
effect unless they are saved.
(7.2) Default parameters
(7.3) Day and night setting
Different parameters need to be set in different light environments.
(7.4) Working mode setting
On the left side of the interface, the working modes of the device are shown, which are Heat mode,
Cool, Heat & Cool mode.
29