For example： Connecting to humidifier
Connect to power cabinet
① Connect a PVC threading pipe at at the bottom of the controller and lock
it tightly;
② Leave the Humidifier signal pipe though PVC pipe, lock the terminal;
③ Insert the terminal into the “Humidifier” identification interface inside
the controller, the end of the signal line connects to the corresponding
interface in the power distribution cabinet.
3).Connect to power after all the connection are ready. Press the knob at “On”, close
the cover, screw tight.
Note:
1. Connect the Master Environmental Control C-1 to the power supply (Please refer to the
parameter table to ensure that the parameters of the power supply are consistent); set the
required parameters on the properly before using it.
2. The operation status of controller will be displayed on the screen, lease learn each signal well
before using.
3. Make sure that the probes (CO
2
sensor probe, and temperature and humidity sensor) are
connected to the probe socket on the bottom of the Master Environmental Control C-1 , and
check if the connector is properly inserted. Place the probe of the light sensor in the place to be
measured, with its front side facing the light source unobstructed.
WARNING:
Do not disassemble the Master Environmental Control C-1 .
Please read the manual first. In case of any questions, consult your dealer.
(To ensure safety, please read this manual carefully and follow the instructions before
installation. If you have any questions, please contact us or consult with your dealer).
3
Clockwise
2
1
Power
PVC pipe
12