w w w . i n n o v a i r . c o m
MULTI-MAX
HIGH WALLS
OWNERS MANUAL
Operation guide
Replacement of batteries in remote controller
1. Press the back side of remote controller marked
the cover of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
signal sender
battery
Cover of battery box
remove
reinstall
NOTICE
●
During operation, point the remote control signal sender at the receiving
window on indoor unit.
●
The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
or wireless telephone; remote controller should be close to indoor unit during
operation.
●
Replace new batteries of the same model when replacement is required.
●
When you don’t use remote controller for a long time, please take out the
batteries.
●
If the display on remote controller is fuzzy or there’s no display, please
replace batteries.
1.
After putting through the power, press "ON/OFF" button on remote controller to
turn on the air conditioner.
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN,
HEAT.
3.
Press "▲" or "▼" button to set your required temperature. (Temperature can't
be adjusted under auto mode)
4.
Press "FAN" button to set your required fan speed: auto, low, medium and high
speed.
5.
Press " " button to select fan blowing angle.
13
Energy-saving function
Under cooling mode, press "TEMP" and "CLOCK" buttons simultaneously to start up or
turn off ener-gy-saving function. When energy-saving function is started up, "SE" will be
shown on remote con-troller, and air conditioner will adjust the set tem-perature
automatically according to ex-factory setting to reach to the best energy-saving effect.
Press "TEMP" and "CLOCK" buttons simultane-ously again to exit energy-saving function.
