18
CONDENSATE DRAIN OPTIONS
HPAC 2.0 is equipped with a pump and spray head which sprays the collected condensate on to the heat exchanger
coil in cooling mode. This evaporates the condensate, eliminating the need for a condensate drain. In heating mode, or if
used to cool in low ambient temperatures (below 73.5°F) this procedure is not feasible and therefore a condensate drain is
required.
Determine where the condensate drain will be located:
IN-WALL DRAIN
This is the best type of drain where it is installed by a plumber inside the wall
DIRECT EXTERIOR DRAIN
This is the easiest type of drain where the condensate drips straight outside.
NEBULIZER:
Innova offers an optional nebulizer kit, which atomizes the condensate in heat mode as a fine mist through an additional
exterior hole.
Follow appropriate instructions on the following pages depending on your particular type of installation.
Note:
The unit does not drain the condensate directly into the drain pipe, but rather it collects into a lightly heated
collection pan (to eliminate icing up of the liquid) where a solenoid valve controls the flow of the condensate from the
internal collection tray to the drain pipe once the maximum level has been reached.
Summary of Contents for Ephoca HPAC 2.0
Page 1: ...1 INSTALLATION MANUAL 2020 ...
Page 9: ...9 ...
Page 17: ...17 NOTES ...
Page 35: ...35 NOTES ...
