1-4
For Safe Operation
1
Flat Panel Sensors Operation Manual 897N200608
Software Precautions
CAUTIONS
Do not install additional software to the system. Do not uninstall any of the software
preinstalled in the system.
The system is preinstalled with the appropriate software. If other software is installed or if the
existing software is uninstalled, various operational errors may result.
Disinfection Instructions
WARNING
Confirm that the respiratory density of disinfectant including solvent is under legal regulation.
Certain disinfectants may damage health. When using a disinfectant, follow instructions
supplied by the manufacturers.
WARNING
Do not use the following disinfectants at the time of disinfection. Doing so may damage the flat
panel sensor and quality, performance and safety of the flat panel sensor cannot be assured.
● Chloric disinfectant which is strongly corrosive to metals and rubber parts.
● Disinfectant whose uses on metals, plastics, and coating are forbidden according to the
instructions supplied with the disinfectant.
● Formalin gas and disinfectant sprays that may get inside the flat panel sensor.
Disinfectant ethanol is recommended for disinfection. Carefully read the instructions and
cautions supplied with the disinfectant before use.
For details on the disinfectant, contact a INNOLUX dealer or the service representatives at the
agency from which you purchased the disinfectant.
CAUTIONS
If flat panel sensor is not disinfected, it may lead secondary infection.
Be sure to disinfect with ethanol after use.
CAUTIONS
Clean the sensor unit of the flat panel sensor with ethanol for disinfection, etc. for each patient
to prevent infection.
Precautions for Charging the Battery Pack
CAUTIONS
● Use the battery charger recommended by INNOLUX Corporation.
For details on operations, refer to the instruction manual for the battery charger.
● Do not charge the battery pack near fire or under strong sunshine. If the built-in protection
mechanisms are activated by a high temperature, the battery pack cannot be charged. Also,
if the built-in protection mechanisms are damaged, the battery pack may be charged with
extremely high current and voltage, and abnormal chemical reactions may occur inside the
battery pack, causing it to overheat, emit smoke, explode or ignite.
● To charge the battery pack, be sure to use the designated battery charger and to observe
the charging conditions specified by INNOLUX Corporation. If the battery pack is charged in
other conditions (temperature or voltage/current higher than specified, remodeled battery
charger, etc.), the battery pack may be overcharged or charged with extremely high current,
and abnormal chemical reactions may occur inside the battery pack, causing it to overheat,
emit smoke, explode or ignite.
