Innolas Laser nanio Series, User And Installation Manual

Page: 43 / 48

9. Interfacing
All external customer connections are made on the rear of the power supply.
1 AC mains in
2 Harting HAN14 interlock connector
3 AMP 7–pin laser head connector
4 AMP 37–pin laser head connector
5 AMP or sub-D chiller connector
6 RS232 electrical connector
7 RS232 optical connnector
8 Firmware upgrade connector. InnoLas use only.
9 BNC Q-switch control connectors
10 User interface connector
Figure 14 - Power supply connections
9.1. Interlocks
Interlock and system reset connections are made using a Harting HAN14 connector.
9.1.1. Emergency stop
Signal name Pin number Function
User_NA1.1 1 Emergency stop loop 1, send. Keep voltage free!
User_NA1.2 8 Emergency stop loop 1, return. Keep voltage free!
User_NA2.1 2 Emergency stop loop 2, send. Keep voltage free!
User_NA2.2 9 Emergency stop loop 2, return. Keep voltage free!
9.1.2. Shutter
Signal name Pin number Function
User_Shutter IL1.1 3 Shutter interlock loop 1, send. Keep voltage free!
User_Shutter IL1.2 10 Shutter interlock loop 1, return. Keep voltage free!
User_Shutter IL2.1 4 Shutter interlock loop 2, send. Keep voltage free!
User_Shutter IL2.2 11 Shutter interlock loop 2, return. Keep voltage free!
9.1.3. System reset
Signal name Pin number Function
User_SystemReset 1 5
Reset Emergency Stop send (can be also done by
turning the keyswitch to position 0 or by RS232
command)
nanio Industrial DPSS Laser User and Installation Manual
35 9. Interfacing