{"local_ipaddr":"192.168.1.10","remote_ipaddr":"212.219.56.184"}
where
local_ipaddr
is the address of the host processor, and
remote_ipaddr
is the resolved
address for the hostname specified.
At that point, a static route will have been created by the BRM between the Ethernet Interface and
the admin connection, and any packet received on the BRM’s Ethernet interface with source and
destination matching the local and remote IP address will be sent out of the admin interface with the
source address replaced with the admin interface IP address.
Select
Remove Admin Connection Route
to remove this route once the download has been
completed.
For more information about the remote firmware upgrade, please refer to
Firmware Upgrading a
BRM-based Terminal Application Note
.
10.11: Reboot
To access this functionality, select
Reboot
from the main menu.
The
Reboot Command
page loads up, per
.
Select the
Reboot
icon to reboot the BRM.
Figure 35. Reboot
A successful reboot of the BRM is indicated per
.
Figure 36. Successful Reboot
10.12: Syslog Destination Config
To access this functionality, select
Syslog Destination Parameters
from the main menu.
This functionality allows you to configure a remote location where syslog files collected on the BRM
must be sent, for analysis and storage.
The
Syslog Destination Config
page loads up, per
66:
BGAN Radio Module Terminal Development Kit User Guide
Confidential and Proprietary – Inmarsat Global Limited
