7: Telnet Sessions
To run a Telnet session on your PC or laptop connected to the BRM, to use AT commands on the
BRM, take the following steps:
Note:
A telnet session cannot be established until at least 30 seconds after the BRM has been
powered on or rebooted, because the BRM does not have a location fix until that point.
1. Access the BRM WebUI and navigate to the
Configuration
page.
2. If they are not already, set
telnet_enabled
to
true
and
bui_mode
to
false
.
3. Start a telnet session on your PC or laptop connected to the BRM.
Notes:
No username or password is required, and the connection address is
192.168.1.1
, port
23
.
The Telnet port is set, by default, to the standard port 23. However, the BRM can be configured to
another port of choice through a configuration parameter.
Refer to
AT Commands Interface Control Document - Telnet
, for which AT commands are
available.
24:
BGAN Radio Module Terminal Development Kit User Guide
Confidential and Proprietary – Inmarsat Global Limited
