>
Select
NONE
in the
config
drop-down menu (any level of config access, i.e., MANF; RSVD;
BASE; NONE, could be provided to an unauthenticated user. Use with caution)
>
Un-check all permissions except
R
(Recommend that if write permissions are provided to an
unauthenticated user, use with caution)
>
Reduce
Grant
level to be less than that set for the
admin
user, e.g., <240
>
Enter
unauthenticated
as the
New User
Note:
The username must be
unauthenticated
.
>
Enter a valid password
Note:
The password will not be required for the unauthenticated user access.
3. Select
Set New Permissions and Password
to create a guest user
4. Log out of the WebUI, then access it again using
in the browser address
bar.
Note:
When switching from a guest user to authenticated user, close and re-open the web
browser.
10.15: Enable_BUI
Selecting this link allows you to enable BUI mode without having to reboot the BRM, in cases where
bui_mode
is set to
false
.
Per
, select
Enable BUI
to enable BUI mode.
Figure 43. Enable_BUI
A subsequent reboot of the BRM would reset
bui_mode
back to
false
.
10.16: IP Access Control List
To access this functionality, select
IP Access Control List
from the main menu.
The
IP Access Control List
page loads up, per
.
This page contains all the resources to run the BRM firewall functionality. It is based in up to 10
different rules which may depend on protocol number, destination port range and/or destination
address.
74:
BGAN Radio Module Terminal Development Kit User Guide
Confidential and Proprietary – Inmarsat Global Limited
