Now make sure the coolant line is secured and
positioned like image above.
Locate the thredded insert on the vehicles frame
below headlight, install and secure the vibra mount.
A) Now install the 1/4” fitting to the factory hose and
secure with factory clamp.
B) Now remove the other side of the hard line.
Connect the 2 lines together and secure using the
factory clamp.
Pull any lines away from the intake tube and remove the
intake tube from the vehicle
Loosen the clips on the hard line and slide back.
This will be removed and secured with a 1/4” vinyl
coupler.
Note: Place a shop rag under neath and
make sure vehicle is cold and not warm, there
will be some coolant leaking.
Pull back the intake tube from the air box.
Loosen the the clamp on the throttle body using
5.5mm socket and extension.
Remove the air box from the vehicle.
With pliers, loosen the clamp on the crank case line
and pull back from engine. Next step will be to
remove the coolant hardline which the Crank case
line is attached to also.
Complete hard line removed.
Now secure the m6 vibra mount to the factory
thredded insert from the stock air box.
Figure 15
Figure 16
Figure 17
Figure 18
Figure 19
Figure 20
Figure 24
Figure 25
Figure 26
Figure 23
Figure 21
Page 3 of Part# SP1571
Figure 22
A
B
