Re-install the bumper cover. Make sure everything is tighten. Position for
best possible fit.
Figure 42
Page 4 of Part# SP1571
1.
Upon completion of the installation, reconnect the negative battery terminal before you start the engine.
2.
Align the entire intake system for the best possible fit. Once the intake has been properly fitted continue
to tighten all nuts, bolts and clamps.
3.
Periodically, recheck the alignment of the intake system and make sure there is proper clearance around
and along the length of the intake. Failure to follow proper mainentance procedures may cause
damage to the intake and will void the warranty.
4.
Start the engine and listen carefully for any odd noises, rattles and/or air leaks prior to taking it for a test
drive. If any problems arise go back and check the vacuum lines, hoses and clamps that maybe causing
leaks or rattles and correct the problem.
5.
Check the filter for excessive dirt build up. Clean or replace the filter with an original Injen filter (can be
bought on-line at “injenonline.com”). Congratulations! You have just completed the installation of the best
intake system sold on the market. Enjoy the added power and performance of your new intake system.
Congratulations! You have just completed the installation of this intake system.
Periodically, check the alignment of the intake, normal wear and tear can cause
nuts and bolts to come loose.
Note: Check clearance and adjust if needed!
Failure to check the alignment and adjust the intake can cause damage that
will void the warranty. Injen Technology is not responsible for any damages
caused by/from improper installation.
Figure 43
Re-connect the MAF sensor harness.
Install the provided 15mm hose to the engine.
Secure the other end of the hose to the fitting on the
injen Intake tube.
Figure 39
Figure 41
Figure 40
