A) Loosen the 2 screws holding in the MAF sensor.
B) Remove the MAF sensor and save screws for later
install.
A) Install the MAF sensor into the new intake tube.
B) Secure the MAF sensor using factory screws and
tighten using phillips screwdriver.
Install the step hose to the throttle body using clamps
provided.
Figure 27
Figure 29
Figure 28
Install the 3” straight hose with clamps to the upper
intercooler pipe, and secure on the intake tube only.
Intall the upper intake assembly into the vehicle and
position to the throttle body and bracket to the vibra
mount.
Position the intake tube for best fit and secure the
bracket using provided fender washer and nut.
Figure 30
Figure 32
Figure 31
A
B
A
B
Install the air filter to the lower part of the intake
assembly, secure and tighten using 8mm nut driver.
Now install the lower part of the intake assembly into
the vehicle from the bottom, and position to the upper
intake assembly.
Place provided vinyl trim to the
frame to prevent contact of intake tube and frame.
Now connect the 2 tubes and position for the best
clearance. DO NOT TIGHTEN!
Figure 33
Figure 35
Figure 34
Now secure the lower part of the intake tube bracket
using fender washer and nut.
Position for the best fit and make sure there is clear-
ance and nothing is touching or rubbing. Tighten all
clamps using 8mm nut driver.
Now tighten both brackets using 10mm socket and
ratchet.
Figure 36
Figure 38
Figure 37
Page 4 of Part# SP1571
