First power up
27
Installation and programming manual
Note
The results obtained by the “Easyscan” regarding the GSM signals should
not be considered constant throughout time, as they are subject to changes
relating to the GSM service.
Therefore, you should carry out the Easyscan operation at regular intervals
or, at least, when the system is undergoing maintenance.
Following is the procedure of the Easyscan function:
1. Powerup the SmartLinkAdv without the SIM card inside.
2. The SmartLinkAdv will initialize (paragraph 5-1 Initializing
phase) and then predispose itself for the Easyscan function for
40 seconds; this period is indicated by blinking on the LED
indicated in paragraph 2-4 Signalling from device.
It is necessary to connect the SmartLinkAdv to a PC while this
time is running, otherwise, once the 40 seconds expires, the
SmartLinkAdv will reinitialize and restart the Easyscan phase.
This procedure is cyclical.
3. Connecting the SmartLinkAdv to a PC (paragraph 4-7 PC Con-
nection).
4. Start the SmartLeague software program and open “SmartLink
Advanced” solution.
5. Go to the Monitoring, Easyscan
6. Click on the Connect SmartLink button to start the connec-
tion with the GSM module.
Once the connection is made, the normal software functions
(Programming functions) will be inhibited.
7. Click on the Start Easyscan button to start the scanning pro-
cess.
The software application will list, in two sections, the GSM net-
work providers in accordance with the detected signal recep-
tion.
8. Click on the Disconnect SmartLink button to interrupt the
scanning operation.
You can utilize this scanning method as often as required.
9. Disconnect your PC.
10. Remove all power from the SmartLinkAdv and insert the SIM
card into its housing (table 2-1, E).
Note
If no SIM card is inserted, the SmartLinkAdv will be unable to function
properly and will continue to implement the phases described at point 2.
