HandPunch 2000 Manual
31
Setup Menu
The Setup menu commands allow you to set the basic operating parameters for the
HandPunch unit. The following section provides a brief summary of all the parameters
that may be set on a HandPunch unit.
Once in the Command Menu, you can step through and set the parameters for each
command sequentially. You do not have to exit command mode after setting any
individual command.
Enter the appropriate password to enter the Setup command menu. Once you have
entered the command menu, there are three options available for navigating the
command menu system.
•
Press
#
to enter the command shown on the display.
•
Press
*
to step to the next command in the menu.
•
Press
CLEAR
to exit the command menu (pressing any numeric key also exits the
command menu). If you are in a command’s sub-menu, press
CLEAR
multiple times to
completely exit the command menu.
There are six commands available from the Setup command menu.
•
Set Language
•
Set Date Format
•
Set Date and Time
•
Set Address
•
Set ID Length
•
Set Serial
Refer to Table 6 on page page 32 and identify the command you need to perform. Step
through all previous commands until you reach the desired command.
NOTE
Navigating
the Setup
Command
Menu
Setup
Commands
