1–2
USING THE TOOL (Continued)
w
When installing or removing the output device on any
tool, ALWAYS grasp a metal component of the tool
while tightening or loosening the Coupling Nut or
Spindle Cap. Acceptable clamping locations include,
but are not limited to, the hex on the Gear Case, the
Tool Hanger, the Torque Reaction Arm or any metal
Mounting Plate. NEVER grasp the composite tool
body or handle in vise jaws to restrain the torque of
the Coupling Nut or Spindle Cap. Such practice will
result in damage to the tool.
•
Do not use power units and gear trains that exceed the
capability of the output device.
•
The Tube Nut Attachment has an opening on the front
side for construction and application purposes. DO
NOT, under any circumstance place your fingers in
this opening.
w
The Torque Reaction Bar must be positioned against a
positive stop. Do not use the Bar as a dead handle and
take all precautions to make certain the operator’s
hand cannot be pinched between the Bar and a solid
object.
w
When operated continuously for long periods of time,
Series D Nutrunners may become hot at the spindle
end of the tool. Take all precautions necessary to
avoid skin contact with the hot surfaces. Prolonged
contact may result in burns.
w
All Series D Torque Control Wrenches and
Nutrunners with reverse capability have rotational
arrows molded into the housing in the area of the
reversing mechanism. When the direction switching
device is positioned nearest the molded circular arrow
with an “F” in the center, spindle rotation will be
forward or clockwise direction. When the direction
switching device is positioned nearest the molded
circular arrow with an “R” in the center, spindle
rotation will be reverse or counterclockwise direction.
WARNING LABEL IDENTIFICATION
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Do not carry the tool by
the hose.
WARNING
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pressure.
90 psig
(6.2bar/620kPa)
International Warning Label:
Order Part No. ___________
