77700-084
Rev.
G
07/02
Page
9
of
13
75.0073 Nov 01 [Rev 8/8/2002]
PROGRAMMING - “CHEAT SHEET”
Function Buttons
Actions
Factory Settings
SENSITIVITY
Press this key followed by the number button (0-9) of the
sensitivity desired.
0 - Minimum
9 - Maximum
Door Closed = 8
Door Open = 8
RELAY HOLD TIME
Press this key followed by the number button (0-9) to enter
the required hold time.
0 = 1 second
5 = 6 seconds
1 = 2 seconds
6 = 7 seconds
2 = 3 seconds
7 = 8 seconds
3 = 4 seconds
8 = 9 seconds
4 = 5 seconds
9 = 10 seconds
1 Second
PATTERN
SELECTION
Press this key followed by a number button (1-9) to select the
required pattern. This setting can be selected for both states
of the door, DOOR OPEN or DOOR CLOSED.
1 = Wide pattern
6 = Middle pattern
2 = Middle pattern
7 = Asymmetric left wide
3 = Asymmetric left narrow
8 = Asymmetric right wide
4 = Asymmetric right narrow
9 = Center narrow
5 = Narrow left
Door Closed = 1
Door Open = 2
RELAY MODE
Press this key followed by a number button (1-4) to select the
required relay output desired.
1-
Passive output
, relay contact open during detection,
closed during non-detection
2-
Active output
, relay contact closed during detection,
open during non-detection
3-
Continuous detection
, relay contact always closed
4-
Continuous non-detection,
relay contact always open
Passive
AUTO LEARN TIME
Press this key followed by a number button (1-9) to select the
required auto learn time.
0 = 30 seconds
5 = 7 minutes
1 = 1 minute
6 = 10 minutes
2 = 2 minutes
7 = 15 minutes
3 = 3 minutes
8 = 20 minutes
4 = 5 minutes
9 = 25 minutes
30 Seconds
(0)
FREQUENCY
Press this key followed by a number button (1-2) to select the
required frequency.
1 = normal frequency
2 = random frequency 1
3 = random frequency 2
Random
Frequency 1
= 2
INQUIRY
Press this button after pressing a function button. Then count
the number of times the LED flashes. This corresponds to
the status of the parameter in question.
No Setting
MAGIC
WAND
Press this button followed by a number button to launch the
desired set-up.
1 = Launch closed door setup (door must be closed)
2 = Launch open door setup (door must be open)
3 = Automatic set-up
4 = Reset to factory default settings
No Setting
PATTERN DEPTH
Press this button followed by a number button (1-3) to choose
your desired pattern depth.
1 = deep pattern
2 = medium pattern
3 = limited pattern
Door Closed = 1
Door Open = 1
?
