77700-084
Rev.
G
07/02
Page
8
of
13
75.0073 Nov 01 [Rev 8/8/2002]
CHANGING THE ACCESS CODE
To change the access code from the factory default setting of 0000, you must complete the following:
1. Think of a 4-digit code that will be easy for you to remember.
2. Press
the button after making the necessary changes to the sensor. After pressing the button, enter your 4-digit
code.
3. Each time you need to change the sensor settings, you must then press the
followed by the 4-digit code you have
set.
4. If the sensor is locked and you do not know the access code, power the sensor off, then power it back on. Press the
Unlock key within 60 seconds of powering. When programming is complete, lock the sensor with a new code, or with
the default code of 0000.
QUICK REFERENCE GUIDE
Dor-O-Matic recommends reading through this guide prior to your installation. We have designed this quick reference to
help you while you are in the field
.
THIS IS NOT TO REPLACE YOUR INSTRUCTION MANUAL!
The 77700-900
is programmed with factory default settings. They are defined in the following steps.
REMEMBER!
If at any time the
factory defaults are appropriate for your application, you do not have to change them. Only change the parameters that
are needed for your application.
INSTALLATION
•
Position the sensor at the bottom of the header on swing side of the door.
•
Utilize the mounting block (87503-600 HMS Spacer) when your doors are loose and partially open due to stack
pressure or wind. Also use 87503-600 HMS Spacer if you are installing 87500-900 door mounted sensors with offset
pivot or hinges.
SET-UP
•
The sensor will automatically learn the door closed position after it is initially powered up. You must then activate the
door so the sensor will learn the door in the open position.
PROGRAM
•
Point the remote control towards the sensor (the receiver is located inside).
•
Start your programming phase by pressing the Unlock button
. The sensor has a 4-digit access code to prevent
unauthorized programming. The sensor is factory preset to have the code of 0000. If you are using the 0000 code,
you will not have to enter the 4-digit code into the remote. You can begin programming immediately after pressing the
button.
•
You must then press a function button, followed by a numerical value.
•
After making all of the necessary changes, slowly press the Lock button twice or the Lock button with your
access code. This will close your programming session.
•
Make all necessary changes in the door-closed position first. Then make changes to your pattern width, depth, and
sensitivity in the door open position.
