77700-084
Rev.
G
07/02
Page
7
of
13
75.0073 Nov 01 [Rev 8/8/2002]
SETTING UP USING THE UNIVERSAL REMOTE
The 77700-900 will automatically learn the door in the closed position after it is initially powered up – this is
indicated by a flashing green LED. Then, the door must be activated so the sensor will learn the door in the open
position.
1.
To Inquire about a Setting, complete the following:
•
Unlock the sensor by pressing the Unlock key .
•
Press the desired function button followed by the Inquiry
?
button. The green LED on the sensor will flash a
certain number of times to indicate the current setting. For example, press the sensitivity button
followed
by Inquiry
?
button. The green LED will flash 8 times.
2.
To Change a Setting, complete the following:
•
Select the desired function button followed by a number. Refer to the quick reference guide for assistance.
•
After the function button is pressed, the red LED will flash rapidly (+/- 10Hz). You will then have 30 seconds
to make a numerical choice. If a number is not entered within the 30 seconds, the sensor will go back into
Lock mode and keep the default setting. For example, press the Auto Learn Time Button
followed by
number 2. The Learn Time will then be set for 2 minutes.
•
Once you are finished programming the sensor, you must then store the changes into permanent memory so
they are retained if there is a power loss. Press the Lock key twice to retain all changes.
3.
To Save Changes, complete the following:
•
Press the lock button
twice. The red LED will flash at a rate of +/-1Hz after pressing the lock button once.
Then the red LED will turn off after pressing the lock button again.
NOTE: The Bodyguard will Auto Learn (green LED flashing) if the sensitivity
,
pattern selection, or pattern depth
was changed during the set-up.
Universal Remote Control 74610-900
1
2
3
4
5
6
7
8
9
0
F1
F2
+
?
Function Buttons
Number Buttons
Unlock Button
Lock Button
