INFOSEC UPS SYSTEM - 4, rue de la Rigotière - 44700 Orvault - FRANCE - www.infosec-ups.com
Hot Line
– Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - [email protected] – 11 17 AA 59 204 18
29
CVCF mode
Descriptio
n
When the input frequency is within 46 to 64Hz, the UPS can
be set to a constant output frequency, 50 Hz or 60 Hz. The
UPS will still charge the battery in this mode.
LCD
display
Battery mode
Descriptio
n
When the input voltage is beyond the acceptable range or if
there is a power failure, the UPS will back up the power from
the battery and the alarm will beep every 4 seconds.
LCD
display
Bypass mode
Descriptio
n
When the input voltage is within the acceptable range and the
bypass is enabled, turn off the UPS and it will enter in Bypass
mode. The alarm beeps every two minutes.
LCD
display
Battery Test
Descriptio
n
When the UPS is in AC mode or CVCF mode, press the
“Test”
key for more than 0.5s. Then the UPS will beep once and start
a
“Battery Test”. The line between I/P and the inverter icons
will flash to remind users. This operation is used to check the
battery status.
LCD
display
Fault status
Descriptio
n
When a fault occurs, the UPS will display fault messages on
the LCD panel.
