EonStor S12S-R/G1032 Installation and Hardware Reference Manual
A12
RX3-
B12
TX3-
A13
GND
B13
GND
Table C-1: SAS Port Pinout Definitions
C.2
COM1 Serial Port Cable
COM1 Cable:
This cable connects between COM1 serial port on the
controller module to the serial port of a management computer. The
serial port’s defaults and requirements are:
1.
Set at 38400 baud, 8 bit, 1 stop bit, and no parity.
2.
In most cases, connecting RXD, TXD, and GND is enough to
establish communications with a terminal.
PN: IFT-9270ASCab
Figure C-2: Adapter Cable for COM1 - Connector Pinouts
CN1 Pin Number
Pin Name
1 Ground
2 TXD
3 RXD
CN2 Pin Number
Pin Name
1 NC
2 RXD
3 TXD
4 DTR
(Shorted)
5 GND
6 DSR
(Shorted)
7 RTS
(Shorted)
8 CTS
(Shorted)
9 NC
Table C-2: COM1 Adapter Cable CN1 and CN2 Pinout
Definitions
C-2
COM1 Serial Port Cable
