EonStor S12S-R/G1032 Installation and Hardware Reference Manual
5.3
for details on handling controller and DIMM
module.
NOTE:
Contact your vendor with information of your surviving controller.
You may access the “System Information” menu in the firmware
configuration utility for details.
Step 2.
Install the replacement controller.
Make sure the
ejection levers are at its lowest position. Align the
controller module with the controller module bay.
Gently slide the controller module in. (See
Figure 5-3
)
Figure 5-3: Installing the Controller Module
Step
3.
Secure the controller module.
Carefully push the
controller until you feel the contact resistance when the
board edge connectors are engaging the backplane. If
unusual contact resistance is felt, remove the controller,
wait for a few seconds and try again. Use the ejection
levers on the sides of the controller to secure it in the
chassis. (See
Figure 5-4
)
When the controller is inserted with the levers at its
lowest position, notches on the levers should properly
clinch to the round metal protrusions on the interior walls
of the module bay. You may then pull the lever upward
to secure the controller into chassis when the controller
is fully inserted.
5-6
Replacing a Controller Module
