EonStor S12S-R/G1032 Installation and Hardware Reference Manual
3. Only use screws supplied within the shipping package.
Longer screws may damage the hard drives.
2.7.2
Drive Installation
Step 1.
Place the hard drive into the drive tray.
Make sure
the hard drive is oriented that the drive’s interface
connector is facing the open side of the drive tray and
its label side facing up. If SAS drives are preferred, the
MUX boards on drive trays should
not
be
used
.
Figure 2-4: Installing a Hard Drive
Step 2.
Adjust the drive’s location
until the mounting holes in
the drive canister are aligned with those on the hard
drive. Secure the drive with four (4) supplied 6/32
flathead screws. See the diagram below for the screw
hole locations using a drive tray with or without a MUX
board.
Figure 2-5: Screw Hole Locations
2-10
Hard Drive Installation
