InfoPrint 6500 Series, User Manual

Page: 80 / 360

80
Chapter 4
Twinax Interface Menu
Hex Transparent Control
This option allows you to enable (the default) or disable additional features
that are not available in standard InfoPrint emulations. To access these
features, send lead-in character text commands in the data stream. You can
also use ASCII codes 80 hex through 9F hex as control codes if configured to
do so.
Lead-In Characters
The Lead-In Character commands must have a start and end code. Set 1 is
the factory default. Three sets (each containing a start and end code) are
available:
•
Set 1 : start code = <% (the default)
end code = >
•
Set 2 : start code =
¬¬
end code = $
•
Set 3 : start code = _%
end code = _
•
User Defined
User Defined Codes
•
Start Code 2: 5F (the default)
•
Start Code 1: 5F
•
Stop code: 5B
The codes can be set to x’40’ - x’FF’ range
Alternate Set 80 - 9F
This selection determines if ASCII codes 80 hex through 9F hex will be used
as control codes or printed as standard printable characters.
•
Printable (the default). Prints the alternate set as standard characters
•
Control Code . Selects the alternate set to be used as printer control
codes.