18
Base
Setup
Infant Seat
Place the Base and Infant Carrier on the vehicle seat, in
a seating position where a child restraint anchor fitting
is installed. Check the Level indicator on the Base (refer
Figure 1). Adjustment can be achieved by either using
the recline foot for more recline, or alternatively the
angle could be altered by placing a firm packing
between the seat and the underside of the Base
(packing can be firmly rolled up towel or nappy).
Step 1:
Step 2:
Step 3:
Step 4:
Base Adjustment
Figure 1
10º to 15º
10º to 15º
Figure 2
Figure 3
ROAD
ROAD
IMPORTANT
!
Always ensure the rearward angle of the Base is approximately 10º to 15º.
STEEP SEAT
STEEP SEAT
Positioning the Recline Foot
To adjust the Infant Carrier recline angle the following is
required;
More Recline
Take the Base and turn over. At the rear of the Base is a
rotating recline foot (refer to Figure 4).
Hold the recline foot and rotate into the reclined
position. (refer to Figure 4).
The recline foot will lock into position (refer to Figure 4).
Ready for installation.
NOTE:
The recline foot adds approximately 5 additional
recline.
Figure 4
If you require more recline place a firm packing
(ie packing can be firmly rolled up towel or nappy)
between the vehicle seat and the underside of the
recline foot of the Base (refer Figure 3).
ADJUST BASE SO THIS LINE IS LEVEL
WITH THE GROUND
Front of Car
