Impacts STREAMER S320RD, Operating Manual

Page: 47 / 68

Operating Manual S320RD
45
7.14 Replacing the Wheel Kit
The Wheel Kit consists of Blast Wheel, Control Cage, Lock Washer, and Bolt.
Demounting:
1. To remove the feed spout (C),
loosen the knurled-nuts (B),
pull the feed spout downward,
and remove the feed spout out
of the housing.
2. Loosen the cage clamps and
remove the control cage (Z).
3. Unscrew the 4 screws of
the front cover plate (F) and
remove.
4. Unscrew the fixing screw (H)
of the blast wheel (R) while
holding the blast wheel still.
Take the blast wheel out of the
housing.
5. Check the wheel adapter (A) for
wear and replace if necessary.
Mounting:
1. Clean all threads and use a new blast wheel fixing screw.
2. Place the blast wheel (R) on the wheel hub (A) through the blast housing opening assuring
the blast wheel fits with the adapter pins (M) in line.
3. Tighten the blast wheel with the fixing screw (H).
4. Fix the front cover plate (F) using the four washers and nuts.
5. Insert the control cage (Z) in the center (see Chapter 7 "Setting the blast pattern") and clamp
the control cage with the cage clamps so that the blast wheel can rotate freely.
6. Turn the blast wheel manually. It must rotate free.
7. Place the feed spout (C) in the housing and fix it with the knurled-nuts (B).