Impacts STREAMER S320RD, Operating Manual

Page: 19 / 68

Operating Manual S320RD
17
3.12 The Automatic Cleaning System
The filter unit is equipped with an automatic cleaning system which cleans the cartridges during
operation of the filter unit. Traditional systems do not allow this. This system mainly consists of 3
components: the compressor, the air splitter, and the electronic timing control. The pressure gauge
and the differential pressure gauge integrated in the filter housing inform about the status of the
cleaning system.
3.13 Abrasive Media
In order to operate IMPACTS blast-machine S320RD
you need hardened, spherical abrasive. The machine
S320RD has been especially designed to be operated
with IMPACTS abrasive.
The IMPACTS abrasive is of very high quality and
owns the rebounding ability required for the efficient
use of model S320RD. The selection of the abrasive
is very important since this is the material to carry out
the surface treatment.
Take off the lid (2) from the separator (1), assure the
wire mesh tray (4) is in place, and fill up abrasive
(3) distributing evenly up to the bottom of the mesh.
Occasionally check function of the deflector shutter.
3.14 Selecting Abrasive Media
Media IMPACTOR S 290
Applications:
• Creates fine profiles and is often used when the surface is only subsequently sealed, for
example, on vacuumed concrete or for the removal of thin layers of paint on non-glazed tiles
Media IMPACTOR S 330
Applications:
• Creates a fine to medium texture on concrete
• Removes glazing from tiles prior to subsequently coating with anti-skid floor sealing
• Removes old impregnations and coatings about 1 mm thick
Media IMPACTOR S 390
Applications:
Standard abrasive, suitable for about 50-60% of all applications. Creates a medium profile on
concrete. Fulfills the same purpose as Media No. 3 when a higher speed of the machine is required,
i.e. on asphalt, in order to keep the thermal load low.