15
3.2 I3N Installation
These I3N modules are suitable for use in the Class I, Division 2, Groups A, B, C and D Hazardous Locations
only. The operating temperature range is -10
˚
C to +60
˚
C.
WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT UNLESS POWER HAS BEEN
SWITCHED OFF OR THE AREA IS KNOWN TO BE NON-HAZRDOUS.
ATTENTION - RISQUE D’EXPLOSION - NE DÉBRANCHEZ PAS L’ÉQUIPEMENT SAUF SI L’ALIMENTATION A
ÉTÉ COUPÉE OU SI LA ZONE N’EST PAS DANGEREUSE.
Devices shall be installed into an enclosure suitable for the environment that is only accessible with the
use of a tool.
1. The I3N modules conveniently mount on a DIN rail.
2. Be sure the DIN rail is in a horizontal position before installing the unit.
3. The orientation shown to the right is necessary to prevent the unit from
slipping off the DIN rail.
4. Align the unit on the DIN rail then push the DIN rail clip until it clicks into
place. Check to ensure that the unit is secure on the DIN rail.
5. Do NOT mount the unit on its side as this may cause the unit from slipping
off the DIN rail.
NOTE
: The spade connector for grounding and the DIN rail clip add to the overall measurements. The
CAN/PWR and LAN connectors also add to the measurements.
NOTE
: Screw holes and a spade connector are available for a mounting option.
