40
To configure the Ethernet settings of the I3N using i3 configurator, go to
Controller
Hardware
Configuration
. If not already done, select the correct connected controller, or use the
Auto Config
button
to automatically recognize a controller that is already successfully connected to I3 configurator.
Below the main controller configuration, under
Network Ports
, find
LAN1
and click on the
Config
button
to the right of the greyed-out ETN300.
In the LAN1 Configuration, fill in the network setup for the I3N. It may be required to consult IT personnel
to determine proper settings if connection to a corporate network is needed.
If
Get settings from
is set to
Configuration
for any parameter, the addresses in the
Default Settings
column will take place when this program is loaded and every time this controller enters RUN mode.
Registers may optionally be defined that will reflect the settings.
If
Get settings from
is set to
Register
for any parameter, the addresses in the
Default Settings
column are
ignored entirely. The addresses instead must come from the configured registers.
