60
11.6 Ethernet Module Configuration
NOTE:
The following configuration is required for all applications regardless of the protocols used.
Additional configuration procedures must be performed for each protocol used.
To configure the Ethernet Module, use i3 configurator Programming Software to perform the following
steps:
1.
On the main i3 configurator screen, select the
Controller
menu and its
Hardware Configure
sub-menu to open the Hardware Configuration dialog (Figure 11.1).
2.
If configuring a different product model than the one shown in the Hardware Configuration
dialog, click on the topmost
Config
button, select the desired PRODUCT Model, and then click
OK.
Figure 11.1 – Hardware Configuration Dialog
