38
9 Safty Notes
In this documentation, text points are highlighted, which require special attention.
Intended Use
Sensors and measuring systems of IMKO GmbH may only be used for the purpose described, taking into account
the technical data. Misuse and use of the equipment other than for its intended purpose are not eligible. The
function and operational safety of a sensor or measuring system can only be guaranteed if the general safety
precautions, national regulations and the special safety instructions in this operating manual are observed during
use.
The moisture sensors and measuring systems of IMKO GmbH are used to measure moisture according to the
measuring purpose and measuring range defined and defined in the technical data. Only adherence to the
instructions described in the manual is regarded as intended use. The manual describes the connection, use and
maintenance of IMKO sensors and IMKO measuring systems. Read the manual before connecting and operating a
sensor or measuring system. The manual is part of the product and must be kept close to the sensor or measuring
system.
Impairment of safety
The sensor or the measuring system has been designed and tested in accordance with EN 61010 safety regulations
for electronic measuring instruments and has left the factory in a safe and safe condition. If the sensor or the
measuring system can no longer be operated safely, it must be put out of operation and secured by means of
marking before further commissioning. In case of doubt, the sensor or the measuring system must be sent to the
manufacturer or his contractual partner for repair or maintenance.
Modifications
For safety reasons, it is not permitted to carry out any modifications or modifications to the sensor or the measuring
system without the consent of the manufacturer. The opening of the sensor or hand-held meter, adjustment and
repair work, as well as all maintenance work other than the work described in the manual may only be carried out
by a specialist authorized by IMKO. The sensor or the measuring system must be disconnected from the power
supply before installation or maintenance work. Do not open or repair the hand-held unit and the power supply!
Hazard Warnings
Danger due to improper operation. The sensor or the measuring system may only be operated by instructed
personnel. The operating personnel must have read and understood the operating instructions.
Danger by electricity
The hand-held meter must not be immersed in water or other liquids. The sensor is insensitive to moisture
contained in the typically measured products. Only connect the hand-held meter to a properly installed outlet
with the supplied voltage supply cable, the voltage of which corresponds to the technical data. Make sure that the
power outlet is well accessible, so that you can unplug the power supply quickly if necessary. Use only the adapter
that is suitable for your outlet.
DANGER:
The Warning Triangle with the exclamation mark
warns you against personal in-jury or property
damage.
