E170301x.03_EN
29/06/2022
19
ATTENTION!
The formation of yellow stains on the stretched fabrics, signals the presence of detergent not carefully eliminated
during rinsing!
The formation of folds on the stretched fabrics can be generated by too low residual moisture. Also pay attention
to the thicknesses of the fabrics. Significant differences in thickness (due, for example, to the lateral seams), can
give rise to the formation of wrinkles and difficulties of insertion.
Even the passage of a double or folded fabric can be the origin of folds or curls, therefore it should be avoided.
The ironing work must not begin until the minimum temperature of 80 ° C is reached, and in any case not before
the minimum temperature necessary for the ironing of the fabrics during processing is reached.
In case of emergency and need for a quick stop of the machine, press one of the emergency buttons on the sides
of the machine. When the emergency button is pressed, the ironing roller stops sand the temperature is above 80
° C, you can burn the ironing bands. If the machine cannot be restarted, use damp sheets by passing them
between roller and bands, and rotating the roller by hand as described in the relevant paragraph. The operation
must be repeated until the temperature drops below 80 ° C.
The ironing area is delimited by ironing bands and introduction bands. Ironing on the outside of the
introduction bands can give rise to stains on the fabrics.
Ironing must be carried out scrupulously following the indications given in the labeling of the fabrics.
In case of absence of labeling, check the composition of the fabrics before deciding on the ironing temperature.
Pay special attention to mixed fabrics and fabrics with seams of heterogeneous material.
16.
WHAT TO DO IN CASE OF ENTRAPPING
The risk is reduced by the presence of hand-saving protection. In the event that, however, the entrapping of a limb
occurs, it is necessary to be able to manually reverse the rotation of the roller, so as to be able to free the limb.
In this case, follow these steps.
Remove the power supply by turning the main switch by placing it on "0".
Use the key, supplied with the documentation, to open the lock of the side door.
Open the door by rotating it on the base
Rotate the flyer:
-
clockwise: to turn the roller in the opposite direction to the ironing and free the possibly trapped limb.
