General Operation
VTM-2000 Installation and Operation Handbook
35
Placing the Vector Display in Line Select Mode
NOTE
: Vector Line Select only functions when in 1H or 2H sweep, or full screen.
Pressing the LINE SELECT button enables the vector pane to monitor a
single line of a video signal. This enables Line Select to monitor
individual areas of the entire image. To view a line in Line Select mode:
1.
Press the LINE SELECT button to place the selected vector display pane in Line Select
mode. At the bottom-center of the display, the pane displays the Line number and Odd or
Even field, as shown in
Figure 3-23
.
Figure 3-23. Establishing Line Select
2.
Press the LINE SELECT button again to alternate between the ODD, EVEN, and all fields.
3.
Rotate the CURVED ARROW knob to select the line to be displayed.
Vector Pane Menu Selections
Pressing and holding the VEC function button selects the Vector pane menu. Use the SETUP
POSITION knobs or the UP, DOWN, ENTER, and EXIT buttons to navigate the Pane menu.
The Vector Pane menu is described in
Table 3-11
.
Table 3-11. Vector Pane Menu
Selection
Selection Option
ANALOG/SD STANDARD
75%
100%
POSITION
USE H POS AND V POS KNOB
CENTER VECTOR
Press SETUP/ENTER
