NEXIO NX1010 Series
Hardware Guide
11
To rack mount the NX1010
plastic retaining mechanism
slide
rail
front rack
posts
rear rack
posts
extension
Figure 1-1
Rack Mounting
1
Attach a slide to each side of the NX1010 using (5) M10 screws. Make
sure the plastic retaining mechanism is located at the back of the NX1010.
2
Attach the extensions to the rear rack posts to match the depth of the racks.
3
Attach the rail to the rack posts.
4
Slide the NX1010 into the rail.
5
Attach the cables to the back panel of the NX1010 as shown below.
6
Turn on the NX1010.
To remove the NX1010 from the rack
1
Stand in front of the NX1010 and pull it out as far as it will go.
2
On the left slide, press down on the plastic retaining mechanism.
3
On the right slide, pull up on the plastic retaining mechanism.
For more information on rack mounting, see the Installation Quick Start
Guide for the appropriate NX1010.
Summary of Contents for NEXIO NX1010 series
