Image Access WideTEK 36CL, Setup Instructions

Page: 38 / 72

Perform Setup
38
➢
To delete the stored data of the white balance calibration, tap DELETE
WHITE BALANCE DATA (2).
➢
After deleting the stored data, run the white balance again, as
described.
➢
If problems arise during the white balance calibration, contact Image
Access technical support, see section
Technical Support starting at page
7.
➢
To return to the previous submenu, tap BACK (1).
➢
To return to the "Start screen", tap EXIT (3).
After a successful white balance, proceed as follows:
➢
Remove the test target.
➢
Put the transport guides back into their position.
➢
Store the test target in a place which is protected from daylight.
➢
Ensure that the test target is not damaged, bent or soiled.