3
TORQUE MEASUREMENT
READ FIRST: SAFETY INFORMATION
For safety, and for damage avoidance, be sure to read this manual
thoroughly. The warranty is only valid when the product is used fol-
lowing the instructions provided within this manual.
●
Do not use tester in high temperature, high humidity, or in damp
or wet areas.
●
Recommended operating temperature is between 0-42ºC (32-100ºF).
●
Do not apply torque exceeding the rated capacity, regardless of
whether the unit is On or Off. Avoid shock load.
●
Do not use lacquer thinner or any solvent to clean the unit.
●
Do not disassemble or modify the unit.
3
INTRODUCTION
GLK Digital Torque Screwdrivers combine ergonomic grips, digital
accuracy and five Go/No Go torque presets that alert users with an
intermittent signal at 90% and a continuous signal at 100% of the
preset using LED and audible alerts (presets cannot be set at less
than 10% of capacity). These torque screwdrivers measure in peak
mode, peak with auto zero reset, and real time. The Go/No Go Counter
counts the number of fasteners tightened within programmed high
and low torque limits. Selectable units of lbf-in, lbf-ft, and cN-m.
LIST OF EQUIPMENT
Torque Screwdriver
Carrying case and Calibration
certificate traceable to NIST
Optional ratchet (RA2)
with 1/4" drive, CW, CCW and
fixed operation
1
2
3
1
2
1
2
3
