Note!
This is the side to be used to wipe the filter - do not use the
other side, as it can do more damage than good!
3. Gently place the folded tissue onto the edge of the filter using two or
three fingers - see Figure 10. Apply firm pressure along the filter's
edge to ensure equal wiping of the entire surface.
Sweep the filter only once. Do not wipe the same area twice with the
same tissue as you might reapply dirt removed in the first sweep,
potentially making things worse.
4. Finally check if the IR filter has been properly cleaned either by
visual inspection or by mounting the camera back to the camera and
making a shot. If further cleaning is needed, repeat cleaning
procedure.
Cleaning with an e-wipe
E-wipes are individually packed wet tissues.
1. Tear at the notch to break seal.
2. Gently remove e-wipe from packaging and without delay begin
cleaning procedure.
3. Fold the tissue to match the width of the surface to be cleaned.
4. Apply firm pressure using two or three fingers at the edge of the
wipe to ensure evenly firm contact to filter surface - see Figure 10.
Wipe surface in one unbroken motion.
User's Guide - Imacon Ixpress
English
Care and Maintenance
47
Technical Specifications
Figure 10: Cleaning the Infrared Filter
