PTZ Parameters
Return Settings
When calling a Preset, the camera adopts the settings uniquely created for that Preset. When an operator moves
the camera from its Preset position, the camera can return to global settings only if programmed to do so through
the Return Settings page.
Procedure 4-3 Enable/Disable Return Settings
Step Action
1
Select
Setup
on the GUI banner to display the setup menus.
2
Select
PTZ Parameters
from the
PTZ Settings
menu.
Select the PTZ Parameters tab.
3
Select the corresponding check box to enable the return settings for:
•
Return to Auto Focus
•
Return to Auto Iris
•
Return to Previous
OR
Deselect the corresponding check box to disable the setting.
The default setting is ‘Enabled’.
- End -
Set North
Direction Indicators permit you to understand the approximate pointing position of the camera to an established
reference point. This reference point is called “North” and may correspond to magnetic north (if it is known) or
some other landmark or fixture. When the camera is initially installed, “North” defaults to a pre-defined position (0°
pan/tilt). You may program the “North” position to be any point along the camera’s pan axis.
Procedure 4-4 Set North Position
Step Action
1
Select
Setup
on the GUI banner to display the setup menus.
2
Select
PTZ Parameters
from the
PTZ Settings
menu.
Select the PTZ Parameters tab.
3
Select
to start the video stream if it is not already active.
The video pane will display the current camera view.
4
Adjust the camera view as required to locate the north position.
Refer to
GUI Camera Controls
on
Page 5
to make the necessary adjustments.
5
Click
Set North
to save the current view as the north position.
- End -
Illustra Pro PTZ Configuration & User Guide
41
